Company News

2017/07/04

Bearing installation
When you get CXB bearing, please mount slewing bearing as instructions below:
(1)Require the installation surface has sufficient strength and rigidity.
(2)Clean bearing and surface of the components, each surface can not have corrosion.
(3)The mounting surface should have locating pin or locating mouth, to prevent the bearing ran to each other.
(4)After contact with the mounting surface, you should check fit clearance with a feeler, the gap can be filled with plastic or a padded to prevent deformation of the bolt tightening.
(5)When installing, ensure that the bearing quenching soft belt should be located in the non-load bearing area or not often load area or load minimum area.
(6)Bearing mounting bolts must be of high strength bolts, according to the loading conditions, select the appropriate intensity level.
(7)Installation washer should adopt flat washer to ensure bearing pre load uniformly.
(8)Bolt preload requires sufficient strength, the preload force is 0.7 times to the bolt material yield limit. Best installed using a torque wrench to ensure uniform force and improve quality of the installation.
(9)Tighten bolts should adopt a "star" cross or symmetrical diagonal tightening way, first pretension and then follow the strength requirements and tighten the bolts.Tighten the bolts needs a torque wrench .
(10)For toothed products,must do the gear backlash detection before tighten the mounting bolts. To ensure the minimum or maximum diameter (with logo) of the gear ring beating meet the design requirements (available 0.05 ~ 0.3mm feeler gauge calibration) .

Slewing ring installation related parameters requirements
(1)Mounting surface roughness is less than Ra12.5.
(2)The maximum allowable values of the installation surface flatness can be determined according to actual working condition, but the flatness change must be uniform increasing or decreasing, within the scope of the circumference of a circle, not allowed to appear more than two (including two) peak, and 100 mm face runout is not allowed within the scope of more than 0.015 mm
(3)Maximum value on the radial direction inclination of the mounting surface is 0.04mm .
(4)Prestressing force of bolt installation must be determined according to the strength level of the bolt,the pre load force is 0.7 times to the bolt material yield limit.